RS4X4HB Series Serial Protocols and Dipswitch Settings Standard Routing B=Both Video and Audio V=Video Only A=Audio Only x=Output y=Input XYZ=Mix Video and Audio: X=Output, Y=Input Video, Z=Input Audio An output may be turned off by routing an Input to 00 Examples: Bxy(Enter) x=Output, y=Input B34(Enter) Audio and Video from Input 4 are routed to Output 3. V86(Enter) Video from Input 6 is routed to Output 8 A42(Enter) Audio from Input 2 is routed to Output 4 B40(Enter) Turns Output 4 Off B123(Enter) Video from Input 2 and Audio from Input 3 is routed to Output 1 Salvo Routing X=Salvo Both Video and Audio Y=Salvo Video Only Z=Salvo Audio Only m=First Output in range n=Last Output in range o=Input number Examples: Xmno(Enter) or Ymno(Enter) or Zmno(Enter) X258(Enter) Send Video and Audio from Input 8 to Outputs 2 through 5 Y123(Enter) Send Video Only from Input 3 to Outputs 1 and 2 Z357(Enter) Send Audio Only from Input 7 to Outputs 3-5 Batch Routing E=Both Video and Audio F=Video Only G=Audio Only EE=Take Examples: Exy(Enter) E21(Enter)F12(Enter)G45(Enter)F82(Enter)EE As a batch do the following after receiving the EE command: Route Both Audio and Video from Input 1 to Output 2 [E21] Route Video Only from Input 2 to Output 1 [F12] Route Audio Only from Input 5 to Output 4 [G45] Route Video Only from Input 2 to Output 8 [F82] Execute [EE] Conference Mode (Cross Connect) J=Both Video and Audio K=Video Only L=Audio Only Examples: Jxy or Kxy, or Lxy J25(Enter) Route Both Audio and Video from Input 5 to Output 2 and Input 2 to Output 5 K25(Enter) Route Video Only from Input 5 to Output 2 and Input 2 to Output 5 L25(Enter) Route Audio Only from Input 5 to Output 2 and Input 2 to Output 5 Timed Sequencer T=Start Sequence N=Stop Sequence nnn=1-999 Examples: Tnnn(Enter) or N(Enter) T135(Enter) will set the time interval to 135 seconds and begin cycling N(Enter) Stops the cycling System Status D= Crosspoint Map D0=Condensed Crosspoint Map Storing and Recalling Crosspoint Patterns S = Store Pattern R= Recall Pattern n= Pattern 1-4 for RS4 and 1-8 for RS8 Examples: Sn or Rn S3(Enter) Store currently loaded crosspoint pattern to location 3 R2(Enter) Recall crosspoint pattern from location 2 DIPSWITCH SETTINGS On Off (Standard) 1 Baud Rate 2 Baud Rate 3 Verbose Non-Verbose 4 Disable Time Sequencer Enable Time Sequencer 5 Disable Breakaway Audio Enable Breakaway Audio 6 Reserved for programming 7 Reserved for programming 8 Reserved for programming General Serial Communications Requirements: 1:1 9-pin Serial (DB9) 8-bit, No Parity, One or Two Stop Bits No Handshaking is required Pin 2 = Transmit Pin 3 = Receive Pin 5 = Ground